Ok i have been playing around with Flowstone a program that Lynxmotion uses for its robots.
I found it compatible with the servator board as it uses also serial commands.
Only difference from the board they use(SSC-32 Servo controller) and the servator is the arrangement of the serial commands.
Lets say you want to move Servo 8 with the SSC-32 board to center. You just type in this command #8 P1500 and for a servator board is #8P1500.
So the diffrence is just one space between the servo number and a letter P.
I made this short test that was derived from this http://www.dsprobotics.com/support/viewtopic.php?f=39&t=351
I just deleted the space in the code and it worked. Il hopefully be doing a complete control software for hexy using the Flowstone software using the already calculated code that some of the guys made for hexy.
As im not a python or any kind of coder its quite easy for me to use this software. Its still hard but the gui based coding helps a lot.
And here is the test i made.
https://dl.dropboxusercontent.com/u/119980971/Flowstone%20Servator%20copatibility%20test.exe