HELP!!!!!!!!!!!!!!!!!!!!!!!!!!!

It’s not clear what problem you are having.

First, congrats on finishing assembling your Hexy!

It sounds like (but not certain) that you’ve got the Arduino software installed. If not, or even if so (so you can check your work), go to github.com/ArcBotics/Hexy/wiki and again see step 2, or perhaps 3.

Just as a general suggestion, try making it easier for people to help you by providing more information about the problem you are having. You might also tone down the exclamation points and smilies (or frownies); one is enough, more gets obnoxious.

If it’s all assembled, the software is all installed, the hexy board is connected via USB and you have power to the servos, then run PoMoCo (see instructions at web sites above). Clicking the action buttons on the left should make hexy do something. The rest is up to you.