but the Arduino ide works, then check if you have an “incoming” blue tooth com port specified
symptoms:
start the PoMoCo.py and the CMD window gives:
Attempting to connect to Servotor
Connection to Servotor failed. No robot movement will occur.
initilizing servos
servos initalizied
Killing all servos
note the lack of a “Trying Windows Method” message
then check if you have any “incoming” blue tooth com ports specified (blue tooth tray icon, right click, open setting , “com ports” tab , direction “incoming”.)
if so, remove it
good message is:
Attempting to connect to Servotor
Trying Windows Method
Connect Successful! Connected on port COMx
initilizing servos
servos initalizied
where COMx is your Servotor com port (seen in device manager - ports (com and lpt) )
side note: typo’s: initilizing servos -> initializing servos
servos initalizied -> servos initialized