Hello Hexy world!
Just finished my Hexy build and am awaiting ordered batteries so haven’t actually tried to make it move YET
I did however successfully upgrade the firmware and install the Arduino IDE software, as well as the drivers, and all the python stuff needed to run the PoMoCo 2.0 beta version.
The good news? It all worked in Windows 10. Just thought someone would like to know.
I’m no programmer, mostly had no clue what I was doing, and it worked… well, up the point of moving, which I’ll let you know how that goes soon.
Treybein
(I know it’s misspelled - 's ok, it’s still very good )