I slavishly followed the set-up instructions and can get the first example program (“do nothing”) to run through the check program cycle OK. However, when I try to upload it, I am told that the board is “Arduino / Genuine Uno” and get the error shown below: When I go to Tools=>Boards, there is no "Arcbotic Sparki.’ board to select. All of the examples get installed, so I know I am doing something right. How do I get the “Arcbotic Sparki” board to show up un the list?
I would appreciate it if someone could set me straight. (My friend has abolutely no problems running it on his Mac).
Arduino: 1.6.9 (Windows 7), Board: “Arduino/Genuino Uno”
C:\Program Files (x86)\SparkiDuino\arduino-builder -dump-prefs -logger=machine -hardware "C:\Program Files Sketch uses 444 bytes (1%) of program storage space. Maximum is 32,256 bytes.
Global variables use 9 bytes (0%) of dynamic memory, leaving 2,039 bytes for local variables. Maximum is 2,048 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x33
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x33
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x33
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x33
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x33
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x33
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x33
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x33
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x33
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x33
Problem uploading to board. See arduino.cc/en/Guide/Troubleshooting#upload for suggestions.