Sparki servo zero offset

The Easy Robot for Everyone!

Sparki servo zero offset

Postby el_rico » Mon Dec 25, 2017 10:59 am

Hello,

Another beginner question... Zero degree for the servo on my Sparki is really not zero. I've removed the screw holding the ultrasonic board and I've tried to reset it in the right angle, but since there are "teeth", it's either a few degrees too much anti-clockwise or a few degrees (even more) clockwise.

There may be obvious way to tune this, but I have no or too little background in this domain...

Thanks!
el_rico
 
Posts: 3
Joined: Sun Dec 24, 2017 6:37 pm

Return to Sparki

Who is online

Users browsing this forum: Google [Bot] and 7 guests

cron